Consumer
Products
Avent Digital Video Baby Monitor

Avent Digital Video Baby Monitor

2.4" color screen SCD603/01

Troubleshooting

My Philips Avent baby monitor parent unit screen is red

If the parent unit of your Philips Avent baby monitor shows a red screen, you can often easily mend it yourself. Find out how.

Red screen on a parent unit

Power supply

Check if the baby unit is switched on and the green power led is lit.

Connection

If your Philips baby monitor parent unit beeps and permanently shows a red screen it might have lost its connection to the baby unit. Follow the instructions below to reconnect your baby unit to the parent unit:

1) Remove the battery from the parent unit
2) Remove the batteries from the baby unit
3) Plug in the adapter of the parent unit and the baby unit

The next 4 steps (step 4 to step 7) are also explained in the video below.

Removing batteries and plugining in the units
Play Pause
You need Flash to see video.
Click here to download it.

Step 4

At the parent unit:

  • Simultaneously Press the 'on' and 'lullaby next' button and keep them pressed until the device is fully started
  • First you will see the AVENT screen, followed by a blue screen
  • Release both buttons when an antenna is shown in the top left corner of the blue screen
Resetting the parent unit

Step 5

At the parent unit:

  • Press and hold the 'lullaby next' button until 'Pairing…' is displayed
  • If the 'Pairing' text does not appear on the display, repeat step 4 and 5 within 30 seconds
Pairing the parent unit

Step 6

At the baby unit:

  • Press and hold the nightlight button, while you switch on the baby unit
  • Hold two seconds before releasing the nightlight button
Resetting the baby unit

Step 7

At the baby unit:

  • Immediately press and hold the nightlight button again until the nightlight button starts to blink
  • Repeat the last two steps until video and audio is present and you successfully paired the baby monitor
Pairing the baby unit

Getting started again

Place the battery back into the parent unit after successfully reconnecting the baby unit to the parent unit. Place new batteries in the baby unit. We recommend only using batteries in the baby unit as a power loss backup.

Placing the batteries

The information on this page applies to the following models: SCD603/01 .

Not what you are looking for?